Home > 80% Lower Receivers >

80 Percent Arms Universal 80% AR-15 Easy Jig
AR-15 80% Arms Universal Easy Jig


 
Alternative Views:


MSRP $149.99
Deal of the Day Price: $115.00
FREE SHIPPING APPLIES TO ENTIRE CART
Savings: $34.99
 

Stock Status :IN STOCK

Product Code: 80J-EASY
Qty:

Description
 

Universal Easy Jig from 80 Percent Arms

A patented device from 80 Percent Arms, the Easy JigⓇ makes it easier, faster and more efficient to complete your 80 percent lower in almost a third of the time it would take on traditional jigs.

The jig is easier because it features a built-in drill and end-mill depth gauge for the trigger and rear-shelf pockets while a quick depth verification setting eliminates slippage, which can ruin parts.

The jig is faster by reducing the number of drilling passes needed. The trigger pocket can be cut in 6 - 11 passes as opposed to 25 passes with a drill press. Router cuts are almost made 5 - 6 times faster than traditional jigs.

The jig is safer on your parts because the end-mill downward force can’t separate the press taper chuck, and it’s more efficient to move the router by hand rather than moving the jig.

The Easy JigⓇ is a tank of a piece of equipment, weighing over 8 lbs and featuring Type III hard anodized components for wear resistance. If you need a jig capable of handling the wear and tear of finishing an 80 percent lower, you can’t do better than the Easy JigⓇ from 80 Percent Arms. Pick up the matching drill bit tool kit, review some of the jig’s specifications and shop at RightToBear.com for the best selection, best prices and best promotions on 80 percent lower parts and tools.


Average Rating: 5 of 5 Total Reviews: 13 Write a review »

  2 of 2 people found the following review helpful:
 
Easy Jig February 8, 2018
Reviewer: Gaffer from Tonawanda, NY United States  
Nice setup. First one took me four and a half hours.Including clean up. Second one four hours with one fifteen minute coffee break. But that’s me. Didn’t want to make any errors. Both lowers turned out like factory ones. Take your time, go slow and the lowers will turn out great. I used a full size router with the spacer to clear the tube. Very happy with result.

Was this review helpful to you?

  2 of 2 people found the following review helpful:
 
great product May 13, 2017
Reviewer: big john from Franklinton, LA United States  
i am a first time builder and can not be happier! i milled two lowers in about five hours including setting up a new drill press. if you can not complete an a/r lower with this just give up. thank for a great product.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
Great product February 20, 2017
Reviewer: Juan Vasquez from Morgantown, WV United States  
This is a great product you get what you pay for and ordering through right to bear you get it fast and about the lowest price you could find

Was this review helpful to you?

  0 of 1 people found the following review helpful:
 
80% lower build components. February 9, 2017
Reviewer: James Ruffino from Villa Park, IL United States  
Haven't used it yet.  But the jig surpassed my expectations.  It shouts quality.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
Great item September 18, 2016
Reviewer: ARAM from Oakdale, CA United States  
This jig is super easy to use and these guys provide it at a good price with free shipping..

Was this review helpful to you?

View All Customer Reviews