Home > Glock Store >

Overwatch Polymer DAT Flat Trigger w/Trigger Bar For Glock

Overwatch Polymer DAT Flat Trigger w/Trigger Bar For Glock


 
MSRP $59.99
SALE PRICE: $55.49
Savings: $4.50

Stock Status :IN STOCK
Product Code: 25622
Qty:

Description
 

Overwatch Precision Polymer DAT Flat Trigger w/Trigger Bar For Glock: 17, 19, 22, 23, 26, 32, and 34

Overwatch Precision is pleased to introduce the first aftermarket polymer trigger for Glock pistols! This trigger is designed to provide the same great feel that the aluminum triggers offer at a reduced cost for the budget minded shooter. As always the flat-faced Overwatch Precision polymer DAT trigger will contribute increased leverage to the shooter as well as a reduction of pre-travel by as much as 20% (depending on frame tolerances) without compromising firearm safety features, resulting in a clean, crisp break and reduced overtravel.

The shoe and safety are solid body polymer attached to a polished OEM Glock trigger bar. The Overwatch Precision Poly DAT is completely drop-in ready and is in stock for Gen 3 and Gen 4 Glock compact / standard pistols. The addition of this trigger alone does not change the pull weight but when combined with our competition trigger spring and Glock OEM minus connector you can expect a reduction in trigger pull weight of one half to one full pound. Please note that we do not tune the trigger bar.

Manufacturer: Overwatch Precision
Model: Polymer DAT
Fits Model: 17, 19, 22, 23, 26, 32, 34 Gen 1-4
Trigger Shape: Flat
Trigger Type: Drop-In
Finish: Polished Trigger Bar
Material: Polymer
Fits Manufacturer: Glock

Average Rating: Average Rating: 4 of 5 4 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
 
3 of 5 Mine was defective February 12, 2021
Reviewer: Alex from DFW  
I'm writing this not to detract you from purchasing but rather to make you consider the aluminum shoe model. Upon delivery I immediately noticed the pin hole is oversized. This causes the shoe to feel VERY sloppy. I've tested this trigger with four different pins and it's pretty obvious something happened in manufacturing.  

Another peeve of mine is that the cross-sectional width of the trigger shoe (where the pin hole is) is significantly more narrow than any other Glock trigger I've owned or handled. I cannot think of a single good reason for this design. You end up with more side-to-side slop when installed.

I've sent a polite email to Overwatch and trust they'll settle this matter. I really like their products but I guess I just have sh*t luck.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Overwatch DAT November 9, 2020
Reviewer: Nicholas from AZ  
In Polymer 80 9/40C with OEM Glock lower parts this trigger is short and sweet.

Was this review helpful to you?