Home > AR Parts > 80% Lower Receivers >

80 Percent Arms Easy Jig Tool Kit
80% Arms Easy Jig Tool Kit


 
MSRP $45.00
 

Stock Status :(Out of Stock)
Product Code: EASY-TOOL
Qty:

Description
 

80 Percent Arms Easy Jig Tool Kit

The Easy Jig™ tool kit contains all the necessary drill bits, milling tools, and drill stop you need to make completing your lower receiver as effortless as possible using the 80% Arms Easy Jig™ system. Click here for the Easy Jig.

Includes:

  • 1x solid Carbide 1/4 inch end mill - custom made with super short 0.75 in flutes for optimal performance
  • 1x 3/8 Drill Bit
  • 1x 19/64 drill bit
  • 1x 5/32 drill bit
  • 1x 3/8 drill stop collar

Average Rating: 4.5 of 5 Total Reviews: 9 Write a review »

  1 of 1 people found the following review helpful:
 
easy jig tools March 6, 2019
Reviewer: Rico 1957 from Acworth, GA United States  
First of all I could not find any of the required jigs at any of the hardware stores big or small. Second they are very good quality tools. Having just graduating from gunsmithing school I can vouch for the quality of the schools tools.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Easy jig tool kit February 8, 2018
Reviewer: Gaffer from Tonawanda, NY United States  
Just wish the mill end was 1/4” longer. Using a full size router, it gets a little sketchy cutting the trigger hole. Other than that, it worked fine.

Was this review helpful to you?

  0 of 1 people found the following review helpful:
 
almost perfect May 13, 2017
Reviewer: big john from Franklinton, LA United States  
the drill bits are the best i have ever used. the end mill bit  chipped on  second lower but completed it with no issues other than will have to buy another one. over all i would buy again.

Was this review helpful to you?

  0 of 1 people found the following review helpful:
 
great April 24, 2017
Reviewer: Roy Lorenz from Roswell, NM United States  
does what it's supposed to do.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Tools March 9, 2017
Reviewer: Bob Van Diest from Fairfield, CA United States  
Worked good. End mill bit held up just go easy as possible. I'll see how well it will do on my second lower.

Was this review helpful to you?

View All Customer Reviews