14.5" Pencil Profile Barrel 5.56 (Midlength) + BG M-LOK Free Float Handguard - 12"

Rating: Total Reviews: (1 review) Write a Review
Product Code:
$124.95 - $138.95
$124.95
Click for Price

14.5" Pencil Profile Barrel 5.56 (Mid-Length) + Builder's Grade M-LOK Free Float Handguard - 7"


Barrel Specs:


This 5.56 chambered 14.5 inch Mid length Barrel is machined from 4150 Chrome Moly Vanadium steel with a QPQ Corrosion Resistant Finish and QPQ coated M4 feed ramp extension.

Quench Polish Quench (QPQ) is a specialized type of nitrocarburizing case hardening that increases corrosion resistance. It is sometimes known by the brand name of Tufftride, Tenifer Black Nitride or Melonite. QPQ is a huge improvement over Chrome Lined barrels. Unlike chrome lining, where the chrome is built up on the surface, QPQ converts the surface without the risk of dimensional build up. 

  • Barrel
    Specifications
    Caliber 5.56
    Length 14.5"
    Material 4150 Chrome Moly Vanadium
    Profile Pencil
    Finish QPQ Corrosion Resistant
    Gas System Length MidLength
    Gas Block Journal .625"
    Dimpled? No
    Twist Rate 1:7
    Muzzle Thread 1/2x28 TPI
    Weight 20.8oz
    Barrel Extension M4 Feed Ramps
    Target Crown 11 Degree


Handguard Specs:


This 12 inch lightweight MLOK rail is compatible with any Mil-Spec AR15 upper. It features elegant cross cuts for weight savings and increased strength. Each component is manufactured right here in Florida to precise tolerances for a firm fit and reliable service. The barrel nut and all mounting hardware included.

Choose from our list of Cerakote colors: Burnt Bronze, Flat Dark Earth, OD Green, Sniper Gray and Tungsten.

Black Rails are anodized
  • 12" free float handguard
  • MIL-STD 1913 Picatinny rail on top
  • 5 M-Lok slots on 3 sides
  • Precision Machined 6000 Series aluminum, for high strength and weight savings
  • Hard Coat Anodized per Mil-A-8625F, Type III, Class 2
  • Clamp on system for easy assembly
  • Steel Barrel nut to resist movement under heat
  • 11.7 oz with barrel nut and hardware
  • 1.35" Inside Diameter
  • 1.63" Wide
  • Made in USA

 
All NFA/ATF Rules Apply

Depending on your state and local laws, you could use this barrel with a lower receiver that is a Registered SBR, or Pistol. Possession of this barrel along with a Non-NFA lower receiver may be Prohibited. We are not lawyers and the above information is not legal advise. Make sure you understand the most up to date federal, state and local laws before proceeding with this product.