Home > AR Parts > Handguards & Rails >

M-LOK Free Float Handguard - 10"
M-LOK Free Float Handguard - 10 inch


 
MSRP $129.99
Deal of the day: $69.95
Savings: $60.04
 

Stock Status :IN STOCK
Product Code: CF-MLOK-10-556-BLK
Qty:

Description
 

M-LOK Free Float Handguard - 10"

This 10 inch lightweight MLOK rail is compatible with any Mil-Spec AR15 upper. It features diagonal cross cuts for weight savings and increased strength. Each component is manufactured right here in Florida to precise tolerances for a firm fit and reliable service. The barrel nut and all mounting hardware included.


  • 10" free float handguard
  • MIL-STD 1913 Picatinny rail on top
  • 5 M-Lok slots on 3 sides
  • Precision Machined 6000 Series aluminum, for high strength and weight savings
  • Hard Coat Anodized per Mil-A-8625F, Type III, Class 2
  • Clamp on system for easy assembly
  • Steel Barrel nut to resist movement under heat
  • 11.3 oz with barrel nut and hardware
  • 1.35" Inside Diameter
  • 1.63" Wide
  • Made in USA

Average Rating: 3 of 5 Total Reviews: 2 Write a review »

  1 of 1 people found the following review helpful:
 
Terrible May 6, 2019
Reviewer: Chuck H from Marietta, GA United States  
Anodizing isn't great and edges are sharp. Editing this review and downgrading it because after going to install it, the top rail does not line up with the rail of my RTB Nickel teflon upper. The rail on the hand guard sits lower than the rail of the upper. Of all the products I've ordered from RTB, this is the only one I've ever had issues with.


***RESPONSE LEFT BY RIGHTTOBEAR.COM:  We are sorry to hear about the discrepancy with the rail.  Due to the mounting style of the rail, you will have some anodizing that becomes scratched on the inside of the rail where it interfaces with the barrel nut, however, this is not visible once the rail is attached.  The anodizing is Type 3 Mil-Spec Hardcoat.  As far as the edges, they should not be sharp; however, they are not chamfered. No rails in this price range are.  If you would like a chafered rail then any of the rails that we sell over $100 will be.  We have not seen an alignment issue before but we would be glad to swap it out or provide a full refund.  Please feel free to reach out to us any time.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Read this!!! April 28, 2019
Reviewer: ROBERT K. from Sahuarita, AZ United States  
To mount this, you're going to need a 30mm crowfoot wrench for your torque wrench.

https://www.amazon.com/gp/aw/d/B002YK9QB8

Kinda which they'd add this to the product details.
Otherwise, it very well built, solid construction. Great price.

Was this review helpful to you?