SLR Rifleworks .625 DIMPLING JIG

Dimpling Jig for .625 Barrels
5 spacing for blocks with .400" .425" .450" .470" and .500" center to center
Includes Jig , Hardened Centering Screw and Custom Hardened Drill bushing
5/32" drill bit required.
7075 Billet T6 Aluminum
5 position flats for Vice mounted drilling to keep barrel stable

Average Rating:

5 of 5 Total Reviews: 5 Write a review »

0 of 0 people found the following review helpful:

Dimpling jig	August 23, 2018
Reviewer: John Aquino from Yigo, GU United States

Great item easy to use

Was this review helpful to you?

0 of 0 people found the following review helpful:

Shoulda bought sooner	August 22, 2017
Reviewer: Chuck M. from The Thumb, MI United States

I've been assembling ARs since 1982, almost always used a factory installed FSB-barrel assembly. The modern type rifle uses a low profile gas block, and a dimpling tool is required for a real quality build. Sure, I have some that aren't dimpled and never moved for 10k+ rounds. But the dimple tool ensures near perfect alignment, and greatly increases the chances the gas block will stay in place. This is a quality tool that is very easy to use and understand, at a ridiculous price. Buy with confidence.

Was this review helpful to you?

0 of 0 people found the following review helpful:

Beyond impressive!	March 25, 2017
Reviewer: Darrin Raymond from Phoenix, AZ United States

Wow! Better than the BRD (Black Rifle Disease) dimpling jig! Definitely gonna get the others so I have all sizes to do this to any barrel! At this price point you cannot go wrong! I've seen it done by eyeballing and by using a gas block to drill the dimples and if you are comfortable taking that risk with a barrel... Go for it! But I'd you want the best in guaranteed "gonna work" gas block setting then get this!
Also, shipping was as fast as Primary Arms! And if you buy parts then you know PA! This is saying a lot for RTB!

Was this review helpful to you?

0 of 0 people found the following review helpful:

Very good	March 1, 2017
Reviewer: Mike Horton from Aurora, IN United States

i was impressed with the quality and workmanship of the jig. It far exceeded my expectations.

Was this review helpful to you?

0 of 0 people found the following review helpful:

just what I needed	September 9, 2016
Reviewer: Timothy H from Hanford, CA United States

I have always just eye balled the gas block and shot some air through it to make sure the gas port is lined up and I have got away with that but then I discovered this tool. Now I can be sure it is properly aligned.

Was this review helpful to you?