Home > OTHER CALIBERS > .22LR >

Model 1 .22LR Pistol Lower Reciever End Cap

22LR Pistol Lower Reciever End Cap


 
MSRP $23.00
 

Stock Status :IN STOCK
Product Code: LRP22EC
Qty:

Description
 

Model 1 .22LR Pistol Lower Reciever End Cap

For use with registered .22LR pistol lower receivers ONLY. Not for use with ANY other caliber. Placing this end cap on any other caliber AR WILL cause catastrophic failure that can lead to injury or death

This .22LR Lower Receiver Endcap takes the place of your buffer tube, end plate and castle nut for your 22 LR build only. To utilize the end cap, the hole for the rear takedown pin spring and detent will need tapped with a 4-40 tap. The correct size set screw will be 4-40 x 1/8" to keep tension on the detent and spring.

Most AR's chambered in 22LR do not need a buffer tube because the action is contained within the carrier assembly. because of this you can remove the unnecessary parts for a more compact 22LR pistol build.

Before installing this part, make sure that your .22LR bolt carrier assembly does not utilize the space within the buffer tube. This .22LR end cap should only be installed by a certified gunsmith.

Average Rating: Average Rating: 4.5 of 5 4.5 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Great purchase November 24, 2019
Reviewer: Mike Mueller from Jeffersonville, IN United States  
AAA+++

Was this review helpful to you?

  2 of 2 people found the following review helpful:
 
4 of 5 22LR End cap June 7, 2019
Reviewer: Ed  
They say 4-40 tap, Get an End plate and file the Buffer tube tang off. worked for me, More "Finished" Look !!!

Was this review helpful to you?